Stainless Steel Sink Manufacturers Share Knowledge Of Drain Pipes

0 votes
asked Sep 9 by afastainlesskb (2,180 points)

Today, Stainless Steel Sink Manufacturers will share the installation method for the stainless steel sink drainer in the kitchen:

  1. Install the drain pipe of the overflow hole
    The overflow hole is a protective hole to prevent the tank from overflowing. Therefore, when installing a water pipe below the overflow hole, pay attention to the sealing property with the joint of the water tank body, and ensure that the water pipe of the overflow hole does not leak water.

  2. Install the drain of the filter basket
    When installing the down pipe under the filter basket, pay attention to the connection between the water pipe and the water tank body, not only to be firm but also to be sealed.

  3. Install the overall drain pipe
    Usually, people buy a water tank with two water filter baskets, but the distance between the two sewage pipes is very close. After installing the workers, the matching drain pipes will be cut according to the actual situation. At this time, pay attention to each interface. The seal between the two creates a common water leak at these joints.

  4. Install the suspension reinforcement groove
    After placing the sink on the work surface, a matching suspension is required between the slot and the work surface, and the sink is securely mounted to avoid small gaps causing the slots to rock from side to side.

  5. Perform drainage test
    After the basic installation is complete, the filter basket will also be installed and the next experiment will begin. When performing the drainage test, it is necessary to fill the water tank and check the drainage of the two filter baskets and the overflow hole. When draining, if there is water seepage, rework immediately to ensure that it will not be used in the future.

  6. Seal around the fuel tank
    After the drainage test is completed, the sink can be sealed without problems. When using a silicone seal, make sure that the gap between the sink and the table is even and that there is no water seepage.

  7. Complete receiver installation
    After the edge strip is completed, the installation of the sink will be completed smoothly. Although the sink is small, due to the high frequency of use, the connection installation of each sewer is more critical.

information about Stainless Steel Sink Manufacturers : https://www.afastainlesskb.com/product/stainless-steel-sink/

Attach File
Stainless Steel Sink Manufacturers2.jpg

Please log in or register to answer this question.

...